Doorgaan naar hoofdnavigatie Doorgaan naar zoeken Ga verder naar hoofdinhoud

Divertor heat load in ITER-like advanced tokamak scenarios on JET

  • G. Arnoux
  • , P. Andrew
  • , M. Beurskens
  • , S. Brezinsek
  • , C. D. Challis
  • , P. De Vries
  • , W. Fundamenski
  • , E. Gauthier
  • , C. Giroud
  • , A. Huber
  • , S. Jachmich
  • , X. Litaudon
  • , R. A. Pitts
  • , F. Rimini
  • EFDA-JET
  • Culham Centre for Fusion Energy
  • Commissariat à l'Énergie Atomique et aux Énergies Alternatives
  • FORSCHUNGSZENTRUM JULICH GMBH
  • École Polytechnique Fédérale de Lausanne

Onderzoeksoutput: Bijdrage aan een tijdschrift › Artikel › peer review

6 Citaten (Scopus)

Samenvatting

Heat loads on the JET MarkIIHD divertor are measured by IR thermography in high triangularity plasmas with edge conditions of advanced tokamak scenarios (AT). AT scenarios operate at low density (ne, av < 5 × 1019 m- 3 at JET) to maximise the non inductive current drive, leading to high target temperature (20 < Te < 40 eV), hence high heat loads. Comparisons with a typical baseline inductive scenario (ne, av ≃ 10 × 1019 m- 3), show that for similar input power (≃ 20 MW) the outer target heat load is higher by a factor 4 in AT scenario, and is above the limit for the ITER-like wall (ILW). Operating long pulses in AT scenarios in the ILW could then be an issue and heat load reduction using impurity seeding is investigated.

Originele taal-2Engels
Pagina's (van-tot)263-266
Aantal pagina's4
TijdschriftJournal of Nuclear Materials
Volume390-391
Nummer van het tijdschrift1
DOI's
StatusGepubliceerd - 15 jun 2009

Vingerafdruk

Duik in de onderzoeksthema's van 'Divertor heat load in ITER-like advanced tokamak scenarios on JET'. Samen vormen ze een unieke vingerafdruk.

Citeer dit